2014 Jeep Grand Cherokee
Mileage
138,890
Service Date
8/26/2026
Services Performed
- X – OK at this time ! – Needs attention —- x Road test for proper handling ! Check brake performance – pulsation in brakes x Check engine operation ! Note any noises – Clunk in rear heard once x Check dash controls x Check heater & air conditioning function x Inspect lights, wipers, & horn ! Inspect & test battery – Rated @ 700 cca – Tests @ 113 cca – Recommend replace battery x Inspect shocks and / or struts x Inspect belts & hoses ! Inspect fluid level & condition – Engine oil low – Power steering fluid low ! Check & note any fluid leaks – Lower oil pan seep 2/5 – No visible power steering leak. Suspect internal leak in the steering rack x Inspect exhaust x Inspect drive axles and / or u joints x Note tire condition – 8/32 x Inspect front suspension x Inspect rear suspension ! Inspect front brakes – remaining _6mm_Front Rotors Warped x Inspect rear brakes – remaining _8mm_ — NOTES: The oil seep from lower engine oil pan is not enough to explain the low engine oil level. Suspect PCV (Positive crank case ventilation valve) is sticking and causing the engine oil to be consumed by the engine. Recommend replace PCV with new and perform engine oil change with BG flush. The BG Flush helps clean and restore the oil passages within the engine. If the piston rings have a build up of carbon it can cause an increase of oil consumption. — Check engine light not on at this time Scanned for codes: 2 history codes stored P0123 – TPS 1 Circuit High P0222 – TPS 2 Circuit Low If check engine light returns diagnostic time will be required — Topped off power steering fluid
- Disconnected the PCV hose and removed the PCV valve from the right cylinder head cover. Cleaned and inspected the PCV valve sealing surface and seal for proper condition. Installed the replacement PCV valve, tightened the mounting fasteners to manufacturer specifications, and reconnected the PCV hose. Verified proper installation and checked for vacuum leaks following the repair.
- Top off oil, add BG Engine performance Restoration Run engine and drive until fully warmed up Drain and Change engine oil Replace engine oil filter, Add BG MOA Engine oil Supplement Check all fluid levels and top up – Put reminder sticker on windshield & reset oil reminder
- Moved the passenger seat forward to access the battery compartment and removed the battery cover, cables, thermal blanket, and hold-down assembly. Removed the existing battery and installed the replacement battery. Reinstalled the battery hold-down, thermal blanket, battery cables, and cover, tightening all connections to manufacturer specifications. Returned the passenger seat to its original position and verified proper vehicle starting and electrical system operation following the repair.
- Removed the front wheels, compressed the brake caliper pistons, and removed the front brake calipers and brake pads. Removed the front brake rotors and cleaned and inspected the caliper brackets, guide pins, and related brake components. Installed new front brake rotors and brake pads, reinstalled the calipers and tension clips, and torqued all fasteners to manufacturer specifications. Reinstalled the wheels, seated the new brake pads, verified a firm brake pedal, checked the brake fluid level, and confirmed proper brake operation following the repair.
Joe T. gave our service a 5 star review on 8/26/2026
